Channel Liner Install and Removal tool
- SKU:
- JCLT
Description
The Glock slide firing pin channel has a part installed in it which is called the channel liner. The channel liner is a tubular shaped plastic part that is pushed into the channel with a special tool and stays in place by way of friction fit. The purpose of the channel liner is to lessen the firing pin spring and spring cup wear and to eliminate the need for lubricant. The liner needs to be removed and replaced with a new one if it gets scored, heavily scratched or when the slide is going to be refinished in an extremely hot environment such as reblueing in a hot tank or when curing finishes in an oven.
Our channel liner tool is designed to both remove and install the channel liner in the Glock slide without damaging the slide.
To remove the channel liner, simply screw the threaded end of the tool into the liner, insert a Glock tool into the hole on the tool and pull the old liner out.
To install a new channel liner, place the liner on the unthreaded end of the tool and push the liner into the channel as far as it will go by hand, then lightly tap the end of the tool with a plastic, wood or brass hammer until it fully seats into the channel.
19 Reviews
-
Great tool
Just what is needed for replacing or removing the firing pin sleeve.
-
channel liner install and removal tool
Needed this tool to finish my slide. Tool worked great. removed old liner and installed new liner in under a minute
-
Channel liner tool
Works as promised.
-
Nice tool
I receved the channel liner tool, looks killer. I will be using it on my new project soon. it's a better looking tool then the one a friend let me use for the last one. 2 Thumbs up..
-
Excellent tool
Works perfectly, used it to first remove a damaged channel liner and then install a new one.
-
channel liner remover
Great tool.
-
highly recommended
bought this last month and got it just a couple of days and I already use it in my built and maintenance . a very good tool to have if your Glock diy shooter
-
Easy to replace with this tool
Great little tool. I know you can make due with a lag bolt for removal and a dowel to set the new liner, but I like having the right tool for the job. Not very expensive either. My only addition would be a cross handle rather than having to use your Glock tool for torque and pulling.
-
Not as good as I hoped
The removal of channel liners works great on this tool. The installation part didn't work as well as I hoped, it ruined two liners. The third liner went in flawlessly. I sanded each liner with sand paper to smooth the edges to help slide in. Either the tool is out of spec or the aftermarket slide has some flaws. Overall it beats the hell out of trying to install using a punch. I would order extra channel liners as cheap as they are just in case you have the same experience I had.
Related Products
RYG Channel Liner Installation and Removal Tool
TangoDown Magazine floorplate Removal Tool
RYG Low Friction Brass Channel Liner For Glock
